OBD-II code · Powertrain (generic, extended)
P2615 Camshaft A Position Signal Output Circuit Low Bank 1
The buffered camshaft A position output that the engine controller sends to other modules (transmission, body, ignition module) is below the expected level on bank 1. Other modules cannot use the cam phase reference for synchronisation.
Is it safe to drive with P2615?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyOutput wire shorted to ground
- PossibleOutput buffer transistor failed
- Less likelyConnector pins corroded - high contact resistance
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Best left to a mechanic
- Typical labour
- 0.8–3 h
- Emissions test
- Usually unaffected
- Parts involved
- Control Module, Signal Output Buffer, Wiring Harness
Related codes
- P23EACamshaft A Position Signal Output Circuit Low Bank 2
- P23EDCamshaft B Position Signal Output Circuit Low Bank 1
- P23F0Camshaft B Position Signal Output Circuit Low Bank 2
- P2612A/C Refrigerant Distribution Valve A Control Circuit Low
- P2613A/C Refrigerant Distribution Valve A Control Circuit High
- P2614Camshaft Position Output Circuit/Open
- P2616Camshaft A Position Signal Output Circuit High Bank 1
- P2617Crankshaft Position Signal Output Circuit / Open
- P2618Crankshaft Position Signal Output Circuit Low
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.