OBD-II code · Powertrain (generic, extended)
P2614 Camshaft Position Output Circuit/Open
The camshaft position output signal sent from the ECU to other modules is interrupted. Other systems that rely on the cam reference (e.g. transmission, hybrid module) do not receive a valid signal.
Is it safe to drive with P2614?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyOpen output wiring
- Less likelyInternal ECU output driver fault
- Less likelyPin pushed back out of connector body
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.5–2 h
- Emissions test
- Likely to fail
- After the fix
- A drive cycle is needed before the light stays off
- Parts involved
- Camshaft Position Sensor, Cmp Signal Wiring
Related codes
- P2611A/C Refrigerant Distribution Valve A Control Circuit / Open
- P2612A/C Refrigerant Distribution Valve A Control Circuit Low
- P2613A/C Refrigerant Distribution Valve A Control Circuit High
- P2615Camshaft A Position Signal Output Circuit Low Bank 1
- P2616Camshaft A Position Signal Output Circuit High Bank 1
- P2617Crankshaft Position Signal Output Circuit / Open
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.