OBD-II code · Chassis
C05F2 Rear Drive Shaft Speed Sensor Circuit Intermittent
Intermittent signal from rear drive shaft speed sensor. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Is it safe to drive with C05F2?
The car may go into limp mode (reduced power). Get it diagnosed before a long trip.
Common causes
- Most likelyConnector loose
- Less likelyConnector with intermittent contact under vibration
- Less likelyHarness routed against vibrating component
Symptoms
- ABS warning light on
- ESC/stability control deactivated
- Possible reduced brake assist
- Speedometer may behave erratically
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.5–2 h
- Emissions test
- Usually unaffected
- After the fix
- A drive cycle is needed before the light stays off
- Parts involved
- Rear Drive Shaft Speed Sensor
Related codes
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.