OBD-II code · Chassis
C05F0 Rear Drive Shaft Speed Sensor Circuit Low
Rear drive shaft speed sensor signal voltage below expected range. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
Is it safe to drive with C05F0?
The car may go into limp mode (reduced power). Get it diagnosed before a long trip.
Common causes
- Most likelySignal wire shorted to ground
- Less likelyConnector pins corroded - high contact resistance
- Less likelyHarness chafing through insulation
Symptoms
- ABS warning light on
- ESC/stability control deactivated
- Possible reduced brake assist
- Speedometer may behave erratically
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.5–2 h
- Emissions test
- Usually unaffected
- Parts involved
- Rear Drive Shaft Speed Sensor
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.