OBD-II code · Network (extended)
U300D Ignition Input On/Start
Fault on the ON/START ignition input line — module sees inconsistent ON or START signal. A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
Is it safe to drive with U300D?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyWiring or connector fault
- Less likelyGateway module routing CAN messages incorrectly
- Less likelyCAN terminating resistor (120 Ω) drifted out of spec
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.5–2 h
- Emissions test
- Usually unaffected
- Parts involved
- Ignition Input, Wiring
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.