OBD-II code · Network
U0416 Invalid Data Received from Vehicle Dynamics Control Module
The Vehicle Dynamics Control Module is present on the data bus but the values it reports are implausible — out of range, frozen, or failing the checksum or rolling-count check. The receiving modules reject the data. Stability control (ESP) is disabled. Causes include a faulty sensor feeding the module, internal computation errors, a software or calibration mismatch after a repair, or bus interference corrupting the frames.
Is it safe to drive with U0416?
Usually safe for short trips, but don’t ignore it: the underlying fault can get more expensive over time.
Common causes
- PossibleVehicle dynamics internal fault
- PossibleCAN corruption causing checksum errors
- Less likelyGateway module routing CAN messages incorrectly
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Hard
- DIY friendly
- Best left to a mechanic
- Typical labour
- 1–6 h
- Emissions test
- Usually unaffected
- Parts involved
- Vehicle Dynamics Module, Can Bus Wiring
Related codes
- U0413Invalid Data Received from Wheel Speed Sensor (Rear, Driver Side)
- U0414Invalid Data Received from 4WD Clutch Control Module
- U0415Invalid Data Received from ABS Control Module
- U0417Invalid Data Received from Park Assist Control Module
- U0418Invalid Data Received from Brake System Control Module
- U0419Invalid Data Received from Brake System Control Module
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.