OBD-II code · Powertrain (generic, extended)
P2A14 Injection Pump Fuel Metering Control C Low (Cam/Rotor/Injector)
The control signal for injection pump metering channel C is below the expected window. Wire shorted to ground or actuator short.
Is it safe to drive with P2A14?
The car may go into limp mode (reduced power). Get it diagnosed before a long trip.
Common causes
- Most likelyControl wire shorted to ground
- PossibleInternal short in metering actuator
Repair at a glance
- Difficulty
- Hard
- DIY friendly
- Best left to a mechanic
- Typical labour
- 2–10 h
- Emissions test
- Likely to fail
- Parts involved
- Injection Pump Metering C, Injection Pump, Wiring Harness
Related codes
- P0253Injection Pump Fuel Metering Control A Low (Cam/Rotor/Injector)
- P0258Injection Pump Fuel Metering Control B Low (Cam/Rotor/Injector)
- P2A18Injection Pump Fuel Metering Control D Low (Cam/Rotor/Injector)
- P2A1CInjection Pump Fuel Metering Control E Low (Cam/Rotor/Injector)
- P2A20Injection Pump Fuel Metering Control F Low (Cam/Rotor/Injector)
- P2A11O2 Sensor Negative Voltage Bank 2 Sensor 3
- P2A12Injection Pump Fuel Metering Control C (Cam/Rotor/Injector)
- P2A13Injection Pump Fuel Metering Control C Range/Performance (Cam/Rotor/Injector)
- P2A15Injection Pump Fuel Metering Control C High (Cam/Rotor/Injector)
- P2A16Injection Pump Fuel Metering Control D (Cam/Rotor/Injector)
- P2A17Injection Pump Fuel Metering Control D Range/Performance (Cam/Rotor/Injector)
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.