OBD-II code · Network (extended)
U302D Ignition Output On/Start
Fault on the ON/START ignition output. A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
Is it safe to drive with U302D?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyWiring or relay fault
- Less likelyGateway module routing CAN messages incorrectly
- Less likelyCAN terminating resistor (120 Ω) drifted out of spec
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.5–2 h
- Emissions test
- Usually unaffected
- Parts involved
- Ignition Output, Output Wiring
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.