OBD-II code · Network
U042F Invalid Data Received From Camshaft Position Control Module
A receiving module detected implausible data from the camshaft position actuator module. Phase angle command vs. actual values fail plausibility checks and are rejected.
Is it safe to drive with U042F?
The car may go into limp mode (reduced power). Get it diagnosed before a long trip.
Common causes
- Most likelyModule internal fault or sensor input drift
- PossibleSoftware version mismatch after replacement
- Less likelyGateway module routing CAN messages incorrectly
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Hard
- DIY friendly
- Best left to a mechanic
- Typical labour
- 1–4 h
- Emissions test
- Likely to fail
- After the fix
- A drive cycle is needed before the light stays off
- Parts involved
- Camshaft Position Module
Related codes
- U042CInvalid Data Received From Chassis Control Module B
- U042DInvalid Data Received From Active Vibration Control Module
- U042EInvalid Data Received From Generator A Control Module
- U0430Invalid Data Received from Tire Pressure Monitoring Sensor
- U0431Invalid Data Received from Body Control Module
- U0432Invalid Data Received from 4-Wheel Drive Clutch Control Module
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.