OBD-II code · Network
U0410 Invalid Data Received from Parking Brake Control Module
The vehicle network receives EPB data that contradicts other inputs (e.g. brake reported applied while moving). Auto-Hold is disabled and EPB warnings are shown.
Is it safe to drive with U0410?
Usually safe for short trips, but don’t ignore it: the underlying fault can get more expensive over time.
Common causes
- PossibleCaliper or position sensor drift
- Less likelyGateway module routing CAN messages incorrectly
- Less likelyCAN terminating resistor (120 Ω) drifted out of spec
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Hard
- DIY friendly
- Best left to a mechanic
- Typical labour
- 0.5–4 h
- Emissions test
- Usually unaffected
- Parts involved
- Epb Module
Related codes
- U040DInvalid Data Received From Turbocharger/Supercharger Control Module A
- U040EInvalid Data Received From Turbocharger/Supercharger Control Module B
- U040FInvalid Data Received From Reductant Control Module
- U0411Invalid Data Received from Wheel Speed Sensor (Front, Driver Side)
- U0412Invalid Data Received from Wheel Speed Sensor (Front, Passenger Side)
- U0413Invalid Data Received from Wheel Speed Sensor (Rear, Driver Side)
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.