OBD-II code · Network
U0119 Lost Communication with Steering Column Control Module
The Steering Column Control Module has stopped transmitting on the vehicle data bus, so other control units no longer receive its messages. Steering-column controls and the steering-lock function can fail. Typical causes are loss of power or ground at the module, an open or shorted CAN/LIN bus wire, a connector fault, or an internal module failure.
Is it safe to drive with U0119?
Usually safe for short trips, but don’t ignore it: the underlying fault can get more expensive over time.
Common causes
- Most likelySteering column module unpowered
- PossibleClockspring failed inside steering column
- Less likelyGateway module routing CAN messages incorrectly
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Repair at a glance
- Difficulty
- Hard
- DIY friendly
- Best left to a mechanic
- Typical labour
- 1–5 h
- Emissions test
- Usually unaffected
- Parts involved
- Steering Column Module, Can Bus Wiring
Related codes
- U0212Lost Communication with Steering Column Control Module
- U0116Lost Communication with Steering Effort Control Module
- U0117Lost Communication with Drive Motor Control Module 2
- U0118Lost Communication with Cabin Air Quality Sensor Module
- U011ALost Communication With Exhaust Gas Sensor Module A
- U011BLost Communication With Rocker Arm Control Module A
- U011CLost Communication With Rocker Arm Control Module B
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.