OBD-II code · Powertrain (generic, extended)
P2C05 A Camshaft Profile Actuator Position Sensor A Circuit Bank 1
The position sensor A of camshaft profile actuator A on bank 1 reports a circuit bank 1 condition. Cam profile selection feedback cannot be measured reliably.
Is it safe to drive with P2C05?
The car may go into limp mode (reduced power). Get it diagnosed before a long trip.
Common causes
- Most likelyPosition sensor failed
- PossibleWiring or connector fault
Symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Best left to a mechanic
- Typical labour
- 1–4 h
- Emissions test
- Likely to fail
- Parts involved
- A Camshaft Profile Actuator Pos Sensor A B1, Wiring Harness, Ecm
Related codes
- P2C09A Camshaft Profile Actuator Position Sensor B Circuit Bank 1
- P2C0DA Camshaft Profile Actuator Position Sensor C Circuit Bank 1
- P2C12B Camshaft Profile Actuator Position Sensor A Circuit Bank 1
- P2C16B Camshaft Profile Actuator Position Sensor B Circuit Bank 1
- P2C1AB Camshaft Profile Actuator Position Sensor C Circuit Bank 1
- P2C02Fuel Pressure Regulator D Control Circuit/Open
- P2C03Fuel Pressure Regulator D Control Circuit Low
- P2C04Fuel Pressure Regulator D Control Circuit High
- P2C06A Camshaft Profile Actuator Position Sensor A Range/Performance Bank 1
- P2C07A Camshaft Profile Actuator Position Sensor A Circuit Low Bank 1
- P2C08A Camshaft Profile Actuator Position Sensor A Circuit High Bank 1
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.