OBD-II code · Powertrain (generic, extended)
P232B Cylinder 11 Fuel Injector A Offset Learning At Min Limit
Cylinder 11 Fuel Injector A Offset Learning At Min Limit: the control module has detected this fault condition. This affects fueling of the associated cylinders.
Is it safe to drive with P232B?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyInjector partially clogged or coked
- PossibleInjector aged - flow rate has drifted low
- Less likelyIncreased contact resistance in injector harness
Symptoms
- Check engine light on
- Misfire or rough idle on the affected cylinder
- Increased fuel consumption
- Possible fuel smell or smoke from exhaust
Repair at a glance
- Difficulty
- Medium
- DIY friendly
- Best left to a mechanic
- Typical labour
- 1–2.5 h
- Emissions test
- Likely to fail
- Parts involved
- Fuel Injector Cyl 11, Injector Wiring Cyl 11, Injector Learning Strategy
Related codes
- P02DACylinder 8 Fuel Injector A Offset Learning At Min Limit
- P02DCCylinder 9 Fuel Injector A Offset Learning At Min Limit
- P02DECylinder 10 Fuel Injector A Offset Learning At Min Limit
- P232DCylinder 12 Fuel Injector A Offset Learning At Min Limit
- P2C52Cylinder 1 Fuel Injector B Offset Learning At Min Limit
- P2C54Cylinder 2 Fuel Injector B Offset Learning At Min Limit
- P2C56Cylinder 3 Fuel Injector B Offset Learning At Min Limit
- P2C58Cylinder 4 Fuel Injector B Offset Learning At Min Limit
- P2C5ACylinder 5 Fuel Injector B Offset Learning At Min Limit
- P2C5CCylinder 6 Fuel Injector B Offset Learning At Min Limit
- P2C5ECylinder 7 Fuel Injector B Offset Learning At Min Limit
- P2C60Cylinder 8 Fuel Injector B Offset Learning At Min Limit
- P2328Ignition Coil J Primary Control Circuit High
- P2329Ignition Coil J Secondary Circuit
- P232ATCM Request Forced Engine Shutdown
- P232CCylinder 11 Fuel Injector A Offset Learning At Max Limit
- P232ECylinder 12 Fuel Injector A Offset Learning At Max Limit
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.