OBD-II code · Powertrain (generic, extended)
P2318 Ignition Coil G Primary Control Circuit Low
The primary control circuit of ignition coil G reads a voltage below the expected level — usually a short to ground on the primary driver wire or a low-resistance fault in the coil primary winding. Coil G cannot build a normal charge, so the cylinder it fires misfires, especially under load. Causes: short to ground in the primary wiring, an internal coil primary fault, or a faulty ECU/igniter driver.
Is it safe to drive with P2318?
Usually safe to drive in the short term. Get it diagnosed when convenient, sooner if the car drives differently.
Common causes
- Most likelyPrimary winding shorted to ground or harness chafed
- PossibleCoil G internal driver fault
- Less likelyConnector pins corroded - high contact resistance
Repair at a glance
- Difficulty
- Easy
- DIY friendly
- Often, with basic tools
- Typical labour
- 0.4–1.2 h
- Emissions test
- Likely to fail
- Parts involved
- Ignition Coil G, Ignition Coil Wiring G, Ignition Module
Related codes
- P2300Ignition Coil A Primary Control Circuit Low
- P2303Ignition Coil B Primary Control Circuit Low
- P2306Ignition Coil C Primary Control Circuit Low
- P2309Ignition Coil D Primary Control Circuit Low
- P2312Ignition Coil E Primary Control Circuit Low
- P2315Ignition Coil F Primary Control Circuit Low
- P2321Ignition Coil H Primary Control Circuit Low
- P2324Ignition Coil I Primary Control Circuit Low
- P2327Ignition Coil J Primary Control Circuit Low
- P2330Ignition Coil K Primary Control Circuit Low
- P2333Ignition Coil L Primary Control Circuit Low
- P2316Ignition Coil F Primary Control Circuit High
- P2317Ignition Coil F Secondary Circuit
- P2319Ignition Coil G Primary Control Circuit High
- P231ACylinder 7 Air-Fuel Ratio Imbalance Adjustment At Limit During Balance
- P231BCylinder 8 Air-Fuel Ratio Imbalance Adjustment At Limit During Balance
Code data: OBDex open dataset (CC0). Labour times are typical ranges, not a quote.